Independent reviews of pressure, water-bath and steam canners, checked against USDA canning guidanceHow we make money
Guide

How to Water-Bath Can, Step by Step

Water-bath canning is the simplest way to start, but it's only for high-acid foods.

Set filled jars on a rack in a canner, cover them with at least 1 inch of water, bring it to a full rolling boil, then start your recipe's altitude-adjusted time; afterward, turn off the heat, wait 5 minutes and lift jars out to cool for 12 to 24 hours.

Updated November 16, 2026 · By the editors of Home Canning Report · We earn from qualifying purchases

Only for acid foods

Use a water bath for fruit, jams and jellies, pickles and properly acidified tomatoes and salsa. Vegetables, meat and stock need a pressure canner.

Steps

  1. Heat the canner. Put the rack in and fill halfway with water. Heat to about 140°F for raw-packed food or 180°F for hot-packed.
  2. Fill jars. Use a tested recipe and the right headspace. Remove air bubbles, wipe rims, apply lids and bands fingertip-tight.
  3. Load and cover. Lower jars onto the rack. Add hot water to cover the tops by at least 1 inch.
  4. Boil, then time. Cover the pot and heat to a full rolling boil. Start timing only then. Keep it boiling the whole time; if it stops, bring it back and restart the time.
  5. Rest. When time is up, turn off the heat, remove the lid and wait 5 minutes.
  6. Cool. Lift jars out upright onto a towel. Leave them 12 to 24 hours, then check seals.

Sterilizing jars

If your recipe's process time is under 10 minutes at your altitude, USDA says to sterilize empty jars by boiling them for 10 minutes first (add 1 minute per 1,000 feet of altitude). For 10 minutes or longer, clean hot jars are enough.

Questions

How much water should cover the jars?

At least 1 inch above the jar tops, according to USDA.

Can I stack jars in a water bath?

Yes, if the canner is tall enough to cover the top layer by an inch and you use a rack between layers.

Keep reading